Our 3D printer membrane is our newest products for 3D printer releasing specially .It is used for 3D printers which (UV curing,SLA and DLP type).It is placed in a tray for the glue to release, instead of silicone film
1. high transmittance, UV light through rate of 92%, the curing time is shorter, better curing effect, higher precision printing;
2. More durable, release more than thirty times the number (refer to the printed page);
3. For many types of UV light curing 3D printer, A money directly to the protective film is peeled off the film, and then the release layer attached to the plastic tank, instead of using a silicone membrane, more convenient to use than the silicone membrane, frequency of use over silicone film, using a method similar to mobile phone film. B section without adhesive, glue around the bottom of the tank needs to have fixtures.
Size: 210 * 290 mm, and about the same size A4 paper, special sizes (20 or more) contact the owner customization.
Thickness: A section 0.125 mm; B, paragraph 0.1 mm.
Note: A paragraph has positive and negative film, after which goes without adhesive protective film, the protective film is peeled off the adhesive tape stuck on that side glue tank; B section is no positive and negative, can be used on both sides.
(Product development phase is currently in trial, is currently testing a small scale trial, so a limited number of sales.)